Sea & Sea YS-110 Instruction Manual download pdf (Page 16)

Connecting the Strobe

E-16

1 Remove the connector cap from the sync cord, and check the

O-ring (strobe/camera or housing)

z Check the O-ring to make sure there are no scratches or debris, and apply

a light coating of the included silicon grease.

2 Remove the strobe’s connector cap

3 Align the convex part on the strobe’s

connector with the notch of the sync

cord’s connector, and then push it

straight in

4 Align 1 with the screws of the

strobe, and then rotate it until it stops

z Tighten it securely.

z When removing the sync cord, loosen 1

and while holding the base of the sync cord’s connector, pull the sync cord

straight out.

z Do not pull the cord.

5 Remove the housing’s bulkhead connector cap

6 Align the round mark on the sync

cord (or the notch of the tip) and the

round mark on the strobe bulkhead

(or the convex part on the inside), and

then push it straight in

Align the B part of the sync cord with

the screws of the strobe bulkhead,

and then rotate it until it stops

8 Rotate the C part of the sync cord

until it stops

z Tighten it securely.

z When removing the sync cord, loosen C first, then B, and then pull the

sync cord straight out holding onto A.

z Do not pull on the cord part.

CAUTION

z Do not touch the connector’s contact pins with fingers. Do not apply

silicone grease to the connector’s contact pins. If contaminated

accidentally, clean the pins by a cotton swab moistened with alcohol.

Marking

Notch 1

ys_110a_e_7.fm Page 16 Tuesday, July 15, 2008 11:29 AM

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 25 26

No comments

Sea & Sea YS-110 Instruction Manual Page 16