Sea & Sea YS-110 Instruction Manual download pdf (Page 10)

Identification of Parts

E-10

OFF Turns the power off. Set the

mode switch to [OFF] when you

are not using the strobe.

Manual1 z Set the mode switch to this

position when you shoot with

manual flash using a compact

digital camera that pre-flashes.

z Set the mode switch to this

position when you shoot with

manual flash connecting the

strobe with a sync cord.

Manual2 z Set the mode switch to this

position when you shoot with

manual flash using a compact digital camera that does not

pre-flash.

z Set the mode switch to this position when you shoot with

manual flash connecting the strobe with a sync cord.

TTL Set the mode switch to this position when you shoot with TTL

flash. When a fiber-optic cable is connected, DS-TTL mode is

activated. “DS-TTL system” (P.

E-22)

TTL lamp Illuminates in red when the strobe is ready to fire. Also

illuminates in green for approximately 2 seconds after firing

with TTL flash output.

CAUTION

z T

he number of times a compact digital camera’s built-in flash will fire

differs among models. Depending on the number of pre-flashes mode

switch settings can differ, so check settings before shooting by conducting

test flashes. “To check the mode switch” (P.E-21)

z [Manual1] and [Manual2] have the completely same performance when

the strobe is connected with a sync cord.

z When 30 minutes has passed from turning on the power, or last emission

of the strobe, the power will turn off automatically (auto power-off). When

turning on the power again, set the mode switch to [OFF] before setting the

desired mode.

Switch, Dial and Button Operation

Mode switch

TTL lamp

ys_110a_e_7.fm Page 10 Tuesday, July 15, 2008 11:29 AM

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 25 26

No comments

Sea & Sea YS-110 Instruction Manual Page 10